Introduction to simulated pressurized coke oven series equipment

40kg simulated pressurized coke oven——TT-YLD1-40KG

Double station 40kg simulated pressurized coke oven——TT-D40K

Technical features

1. Supporting the long-life coal steamer independently developed and produced by our company, the wall thickness is 10mm, and the service life is more than 6 months under normal use; while the wall thickness of similar products is 5-6mm, and the service life is only 2 months, resulting in higher subsequent use costs . The structure of our company's coal steamer adopts seamless pipe integral molding structure; while the coal steamer of similar products is mostly welded on the side after coiling, and the welding port is easy to open and welded in the later stage, causing experimental tar to overflow, adhere to the furnace wire and burn the furnace. The furnace can be used normally for 2 years, so that the furnace needs to be replaced every 2 months, which increases the additional cost of use.

2. Equipped with the tail gas environmental protection purification device independently developed by our company. High-efficiency combustion in the chamber and post-water film injection are adopted to realize pollution-free discharge. The entire coke oven facility can work safely even if there is a sudden power failure.

3. Three-phase balanced power supply is adopted, and the balance of the power grid is used to precisely control the temperature of the middle and lower sections of the furnace wall at the same time, ensuring a good correlation between the coking result and the coke oven production. And it can be replaced separately to reduce the cost.

100kg simulated pressurized coke oven——TT-100K

Technical features

This system is a test coke oven between the 200kg semi-industrial test coke oven and the laboratory 7kg and 20kg small coke oven. It not only retains the advantages of the 200kg coke oven, but also overcomes the large amount of coal sample and long coking cycle. The disadvantage of high labor intensity is the replacement of 200kg coke oven. At the same time, it also overcomes the shortcomings of the laboratory's 7kg and 20kg small coke ovens with narrow oven width and small coke sample volume. It has a coal loading capacity of ≥40kg at a time, and uses a 1/4 meter Kum drum to achieve coke identification and industrial coke ovens. The purpose of coke identification is similar (this is difficult to achieve in 7kg and 20kg coke ovens). The unique structural design and the use of three balanced loads are used by computers and PLC to achieve separate and precise temperature control of the furnace walls, ensuring a good correlation between the coking results and the production of coke ovens. The coke strength index is intuitive and the test results have good reproducibility.

This series of equipment is also called load coke oven, test coke oven, simulated pressurized coke oven, load test coke oven.

Our company's 40kg simulated pressurized coke oven is also called loaded coke oven , test coke oven , 40 kg small coke oven , etc. It is used with coke oven tail gas environmental protection purification device.

Our company's double station 40kg simulated pressurized coke oven is also called 80kg load experimental coke oven, 80kg coke oven, double-station coke oven, double station 40kg coke oven, etc. It is used with coke oven tail gas environmental protection purification device.

Our company's 100kg simulated pressurized coke oven is also called 100kg load test coke oven, 100kg coke oven, etc. It is used with coke oven tail gas environmental protection purification device.